Planet VGW 10 Series User Manual page 53

2) Input a connection name, and press the Enter key or use the mouse to click "OK" to enter the
next step. Then there will be a "connected" dialog. In the "Connect using" pull down menu,
your selected port must be in accordance with the port actually connected to the PC as shown
in picture below.
Press Enter or click on the "OK" button to enter the next step to set port's other attributions.
3)
Port attributions should be set as follows：

Bits per second：9600

Data bits：8

Parity：None

Stop bits：1

Flow control：None
Press Enter key or use mouse to click "OK".
4) If the device has been started (device automatically starts when power is on), you can see the
user login message.
4-/8-Port SIP Internet Telephony Gateway
Figure 6-1-4
HyperTerminal configuration
Figure 6-1-6
Serial login
Page 48
VGW-x10 Series
Figure 6-1-5
Serial settings