Login Conditions; Login - Planet VGW 10 Series User Manual

SIP
Configuring parameters for administrator-level and operator-level users are as follows:

The identity of administrator has a key to overwriting Web configuration parameters.

The identity of operator is restricted to certain Web configurations, such as configuration
items from "User Management", "Config Backup", "Default Settings", "Device
Information" and so on.

3.1.2 Login conditions

In order to visit web configuration, besides correcting physical connection of network cable,
you should pay attention to items below:
 Configure your PC's network setting and make sure PC and VGW are in the same
network group (such as VGW's IP: 192.169.0.1, and PC's IP should be between
192.169.0.2 -- 192.169.0.254). For details, please refer to " 3.1.1 Factory parameters " .

Please use IE 6.0+ or other popular browsers to access web configuration.

3.2 Login

The device is configured by the web interface. The following steps will enable you to log
in:
1） Follow "Installation Preparation" to install;
2） The device default IP is 192.169.0.1;
3） Open your web browser, and type the device IP in the address bar;
for example, http://192.169.0.1:8008
4） Entry of the username and password will be prompted. Enter the default login User
Name , Password and Verification Code.
The default login User Name of administrator is "admin", and the default login
Password is "psw.iad".
4-/8-Port SIP Internet Telephony Gateway
Server Port: 5060
Local SIP Port: 5060
Page 12
VGW-x10 Series