Chapter 6 Faqs; Cli Maintenance Tools; Telnet Login - Planet VGW 10 Series User Manual

6.1 CLI maintenance tools

CLI is a command-line terminal maintenance tool. In order to solve problems efficiently, you
should have a certain understanding about the following details.
The following procedure parameters are "factory default ". For more parameter information,
refer to "3.1.1 Factory parameters". When dealing with the issue, you should do according to the
actual configuration parameters.

6.1.1 Telnet login

We can make configuration on command-line terminal，manage device in-band.
When configurate VGW's technical parameter, we could use "telnet" to login.（First, ensure
that device's power is on, LAN port default IP is 192.169.0.1, subnet mask is 255.255.255.0）We
can make configuration from command terminal, manage device in-band.
VGW gateway allowed telnet to login WEB configuration by LAN or WAN port。However,
due to the WAN port IP address might be dynamically obtained through DHCP and PPPoE, which
is not easy for "telnet" to access, so it is strongly recommended that keep the LAN port to connect
"telnet". "telnet" login process can be performed as follows:
Prepare a direct or a cross network cable.
Keep network cable connect PC and VGW's LAN port. If the LAN port LINK led is on, it
means that PC and device has been properly connected.
Modify/Add the PC IP address192.169.0.X (X is an integer greater than 2 and less than 254)
mask of 255.255.255.0.
Open a command line window on PC。 （From the windows menu<start>, <Run>, where you
can input "cmd" command or "command", then click "OK" to open cmd.exe.）
Input the following command in the command line window: telnet 192.169.0.11250 refer to
the following picture:
1) Press enter，Telnet into the device's login screen, as shown below：
4-/8-Port SIP Internet Telephony Gateway
Figure 6-1-1
VGW Telnet login
Page 46
VGW-x10 Series

Chapter 6 FAQs