Configuring Io-Link Devices; Port Pages Overview; Editing Parameters - Io-Link Device - Port Table - Leuze electronic MD 748i Connecting And Operating Instructions

9

Configuring IO-Link Devices

This chapter discusses using the Attached Devices | Port pages to change IO-Link device parameters.
Note: Optionally, you can use traditional methods such as: PLC interfaces to configure the IO-Link devices.
9.1

Port Pages Overview

You can use the Attached Devices | Port page for a port to review and easily edit the IO-Link device
configuration.
Figure 37:
The Port page provides two IO-Link device configuration methods:
 IO-Link Device Port table (GUI), which depends on the appropriate IODD file loaded from the IO-
Link device manufacturer onto the IO-Link Master. To use the IO-Link Device Port table for
configuring IO-Link devices, refer to the following subsections:

Editing Parameters - IO-Link Device - Port Table


Resetting IO-Link Device Parameters to Factory Defaults

 IO-Link Device ISDU Interface - Port, which can be used with or without IODD files loaded. Refer
to the following information to use the IO-Link Device ISDU Interface - Port method:
IO-Link Device Operator Manual
 The
Link Device ISDU Interface since ISDU block index and ISDU sub-index numbers are
required.
Editing Parameters - IO-Link Device ISDU Interface - Port

9.2 Editing Parameters - IO-Link Device - Port Table
Use the following procedure to edit IO-Link device parameters using the IO-Link Device Port table.
Leuze electronic
IO-Link port overview page
from the device manufacturer is needed to use the IO-
MD 748i / MD 248i
9 Configuring IO-Link Devices
60