Table of Contents
Advertisement
D2 Digital I/O Configuration
Mode
Default
= Off
Invert I/O
Default
= False
Default Digital Output
Default
= Off
Input Settling Time (0 - 10000ms)
Default
= 0ms
D3 Digital Input Configuration
Mode
Default
= Off
Invert Input
Default
= False
Input Settling Time (0 - 10000)
Default
= 0ms
D4 Digital I/O Configuration
Mode
Default
= Off
Invert I/O
Default
= False
Default Digital Output
Default
= Off
Leuze electronic
Digital I/O Settings Page
Selects the Mode:
•
Off – No monitoring or setting of the digital I/O pin.
•
Digital-Input – monitors the digital input status
•
Digital-Output – sets the digital output to either the default
setting or value received from a controller.
If selected:
•
If Mode is set to Digital-Input, the input status is inverted.
•
If Mode is set to Digital-Output, the output setting is inverted.
If Mode is set to Digital Output, defines the default digital output
setting:
•
At startup before a controller can set the digital output.
•
When communication to all controller(s) has been lost.
Possible settings:
•
Off - low voltage
•
On – high voltage
If non-zero and Mode is set to Digital-Input, the required time
that the input status must remain constant before an input
status change is reported.
Selects the Mode:
•
Off – No monitoring of the digital input pin.
•
Digital-Input – Monitors the digital input status
If Mode is set to Digital-Input, the input status is inverted.
If non-zero and Mode is set to Digital-Input, the required time
that the input status must remain constant before an input
status change is reported.
Selects the Mode:
•
Off – No monitoring or setting of the digital I/O pin.
•
Digital-Input – Monitors the digital input status
•
Digital-Output – sets the digital output to either the default
setting or value received from a controller.
If selected:
•
If Mode is set to Digital-Input, the input status is inverted.
•
If Mode is set to Digital-Output, the output setting is inverted.
If Mode is set to Digital Output, defines the default digital output
setting:
•
At startup before a controller can set the digital output.
•
When communication to all controller(s) has been lost.
Possible settings:
•
Off – low voltage
•
On – high voltage
MD 748i / MD 248i
7 Dedicated Digital I/O Port Configuration
50
Advertisement
Table of Contents
