Leuze electronic MD 748i Connecting And Operating Instructions page 32

Note: Do not configure Data Storage until the IO-Link device is configured. Data Storage, Device Validation, and
Data Validation are discussed in chapter 10 Utilizing IO-Link Master Features.
You can use this procedure to configure IO-Link settings for each IO-Link port.
If an IO-Link device is attached to the port, no configuration is required for operation. If a digital input or
output device is attached, it is necessary to change the Port Mode.
1. If necessary, open the IO-Link Master web interface with your web browser using the IP address.
2. Click Configuration | IO-Link Settings.
3. Click the EDIT button for the port or ports that you want to configure.
Figure 17:
Note: You can click each EDIT button and open all ports to quickly configure port parameters.
4. Make appropriate selections for the device that you connected to that port.
Make sure you select the DigitalIn option for a digital input device and the DigitalOut option for a digital
output device for the Port Mode.
The IO-Link Master negotiates the Minimum Cycle Time so it is not necessary to set a cycle time unless
you need a specific cycle time.
You can use the help system if you require definitions or values for the options or refer to the following
table.
Note: Do not configure Data Storage until the IO-Link device is configured.
Note: Do not enable Automatic Download and then attempt device configuration as Automatic Download
changes the settings back to what is stored on the IO-Link Master. Data Storage, Device Validation, and
Data Validation are discussed in 10 Utilizing IO-Link Master Features.
Leuze electronic
Web configuration IO_Link interface
3 Configuring the IO-Link Master with STEP 7
MD 748i / MD 248i 32