Assigning An Ip Address Statically (Local) - Leuze electronic MD 748i Connecting And Operating Instructions

4. Change IP Type from static to dhcp.
Figure 5: Web Network Configuration Page: DHCP setting
5. Click the SAVE button.
Once DHCP is enabled, the IO-Link Master attempts to obtain an IP address from a DHCP server. If a new
IP address is assigned by a DHCP server, then the IO-Link Master switches to the new IP address
immediately. This may interfere with communications between the device and the IO controller.
The Obtain IP address from a DHCP server option in the
7: Configure IP Address and Device Name) is not supported. DHCP can only be enabled or
disabled via the web interface.
Note: An IO controller can overwrite DHCP IP assignment by assigning IP address via DCP.
The next configuration step is to assign the device name, see 3.5 Device Name Assignment.
3.4.3

Assigning an IP Address Statically (LOCAL)

IP addresses can also be assigned statically using one of the following methods:
 The LOCAL method as defined in the GSDML Specification
 Embedded web interface
3.4.3.1 Assign IP Address Statically Using STEP 7
Use the following procedure if you want to use the LOCAL method using STEP 7.
1. In the STEP 7
window.
Leuze electronic
HW Config
window, double-click the IO-Link Master object to open up the
MD 748i / MD 248i
3 Configuring the IO-Link Master with STEP 7
Edit Ethernet Node
window in STEP 7 (Figure
Properties
18