Mounting The Io-Link Master; Md 748I-11-42/L5-2222 - Mounting; Md 248I-12-8K/L4-2R2K - Mounting - Leuze electronic MD 748i Connecting And Operating Instructions

 Program the IP address using the web interface. Refer to chapter 3 for configuring the network
information.
 If using the rotary switches to set the IP address, then you are ready to attach devices using
chapter 6.
If the LEDs do not meet the above conditions, you can refer to the IO-Link Master
Troubleshooting and Technical Support.
2.4

Mounting the IO-Link Master

Use the appropriate procedure for your IO-Link Master hardware type.
2.4.1

MD 748i-11-42/L5-2222 - Mounting

Use the following procedure to mount the IO-Link Master. You can mount the IO-Link Master on a mounting
panel or a machine.
1. Verify that the mounting surface is level (flat) to prevent mechanical stress to the IO-Link Master.
2. Attach the IO-Link Master to the surface with two 6mm screws and washers, torque down to 8Nm.
2.4.2

MD 248i-12-8K/L4-2R2K - Mounting

You may want to mount the IO-Link Master after programming the IP address and connecting the IO-Link
and digital input/output devices.
1. Slide the metal latch down, hook the top of MD 248i-12-8K/L4-2R2K to the DIN rail and release the
latch.
2. Verify that is tightly mounted.
Note: You may want to connect the IO-Link devices before attaching the MD 248i-12-8K/L4-2R2K to the DIN
rail. Use chapter 6 you require IO-Link cabling information.
Leuze electronic MD 748i / MD 248i
2 Hardware Installation
LEDs
in chapter 13,
13