VCS VideoJet 1000 Manual page 40

Configuration with Web Browser
Video loss alarm:
Select the option On to monitor the input signal from the video
source (camera). If the signal drops out an alarm is generated on
the VideoJet 1000.
Alarm on min. contrast:
The VideoJet 1000 can trigger an alarm in case the camera picture
shows only little contrasts, e.g. when the lens was sprayed with
color or covered. Choose the option On to activate this function.
Video input termination:
Select her the option On, to terminate the video input if the video
signal is not to be looped through (e.g. with a T-plug).
Camera name stamping:
Here you can set the position of the camera name stamping. It can
be displayed on Top or on Bottom of the image or you can define
a position yourself via the Hyperterminal and activate it choosing
the option Custom. If you do not wish the name to be displayed,
select Off.
Time & date stamping:
Here you can set the position of the time and date stamping. It can
be displayed on Top or on Bottom of the image or you can define
a position yourself via the Hyperterminal and activate it choosing
the option Custom. If you do not wish time and date to be dis-
played, select Off.
Motion detector The VideoJet 1000 contains an integrated video sensor, which on
the basis of the video processing can register changes in the video
signal. These changes are primarily initiated by movement in the
field of view of the camera.
The sensitivity of the video sensor can be adjusted, so that an alarm
is generated only if a given threshold is exceeded.
In order for the alarm to operate, the following conditions must be
fulfilled:
!
!
38
The motion detection must be activated.
At least one cell must be activated.
VideoJet 1000