VCS VideoJet 1000 Manual page 21

Single unit For the installation of a single unit, one short and the long angle
bracket from the Mounting Kit are required.
"
Screw the two brackets to the sides of the unit housing.
"
If necessary, remove the rubber feet from the base of the unit if any
other equipment is to be mounted directly underneath.
"
Mount the unit into the rack and secure the angle brackets using
four screws.
"
Plug the supplied mains cable into the Power socket on the rear of
the unit.
Two units For the installation of two units, the two short angle brackets and
the two rails from the Mounting Kit are required.
The two units must first of all be bolted together.
"
Lay the two units alongside each other on their backs and secure
the two rails to the units using four screws for each unit.
"
Screw the two short angle brackets to the outsides of the two units.
"
If necessary, remove the rubber feet from the base of the unit if any
other equipment is to be mounted directly underneath.
"
Mount the units into the rack and secure the angle brackets using
four screws.
"
Plug the supplied mains cables into the Power sockets on the rear
of the two units.
VideoJet 1000
Installation
19