VCS VideoJet 1000 Manual page 111

Network settings
The settings on this page are used to integrate the unit into an exist-
ing network.
Unit IP address:
Enter here the required IP address for the VideoJet 1000. The IP
address must be valid for the network.
Warning!
Changes in IP address, subnet mask and/or gateway IP address
are transferred to the device by clicking on the button Set, but they
are only valid after a reboot!
For a reboot simply enter the old IP address into the address bar of
the Browser followed by /reset, after that the unit can only be
accessed via the new IP address.
Subnet mask:
Enter here the corresponding subnet address if the unit is to com-
municate via a subnet.
Gateway IP address:
Enter here the appropriate IP address if the unit is to independently
establish a connection outside of the local network. This field can
otherwise remain empty (0.0.0.0).
Video/Audio transmission:
If the device is used in front of a firewall, transmission over TCP
(Port 80) should be selected. If used in a local network select UDP.
VideoJet 1000
Configuration with Web Browser
109