VCS VideoJet 1000 Manual page 24

Installation
Note
Where possible, a switch with minimum contact bounce should be
used as activator.
"
Remove connector block from Input socket.
"
Insert conductor into connector and secure tightly – check that
screws are securely tightened.
"
Replace the connector firmly back onto the Input socket.
Switched output The VideoJet 1000 is provided with a relay output for switching
external equipment, e.g. lamps or acoustic alarms. This switched
output can be manually activated during an active connection with
the VideoJet 1000. In addition, when suitably configured the output
can be activated as a response to an alarm signal, for example, to
automatic acoustic alarms or to other devices.
Warning!
The maximum rating of the relay contact is 40 V and 0.8 A.
"
Remove connector block from Output socket.
"
Insert conductor into connector and secure tightly – check that
screws are securely tightened.
"
Replace the connector firmly back onto the Output socket.
22 VideoJet 1000