Table of Contents
Advertisement
Programming the
To set drive parameters using the keypad, first make sure the drive is stopped.
Parameters cannot be changed while the drive is running. To enter the programming
menu, press the Program Key (PRG) on the keypad. To return to the previous screen,
press either (PRG) or (RESET). To select a menu item, use the (UP) and (DOWN) keys
on the keypad, then press the (FUNC/DATA) key to go to that screen. Refer to the
diagram below for an example of navigating the menu:
Function code settings can be changed using the (UP) and (DOWN) keys on the
keypad. Pressing (FUNC/DATA) saves the changes, while pressing (RESET) discards
the changes, and both return to the previous menu.
The most frequently modified parameters can be accessed in the 'Quick-Set' menu (item
0 on the programming menu screen). All parameters can be accessed in the 'Data-Set'
menu (item 1 on the programming menu screen).
Recommended user-set drive parameters
These parameters are all in the
F07 Acceleration Time.
F08 Deceleration Time.
F10/F11 Electronic Overload.
F14 Restart Settings. Refer to drive instruction manual.
F26 Motor Sound (carrier frequency).
P02 Motor Capacity (HP).
P03 Motor FLA.
P04 Motor Tuning. Refer to drive instruction manual.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Drive
FRENIC-Eco
drive Quick-Start menu for easy access.
FRENIC-Eco
Page 17 of 22
(cont'd)
Advertisement
Table of Contents
