Table of Contents
Advertisement
Wiring Overview
The
panel must be connected to an input power source, a motor
FRENIC-EcoPAK
(output power), and control signals.
WARNING
Wiring should be performed by a qualified electrician using standard practices as
specified by local and national codes.
Always make sure the input power source is OFF before connecting or disconnecting
any power input, output, or control wiring.
Ground the panel, as specified by local and national codes, using the provided
grounding lugs or bus bar.
Make sure that the input power source (phases, voltage, and current capacity)
matches the requirements of the panel as stated on the nameplate.
Never connect line voltage to the drive output terminals (U, V, and W).
When making holes for conduit fittings, be sure to cover the drive and other
components to protect them from metal shavings.
CAUTION
All field wiring should be copper with a minimum insulation rating of 75°C.
Sizing of field wiring conductors should be based upon the current ratings listed on
the nameplate label, in accordance with local and national codes.
Refer to the wiring diagram that shipped with this panel and the torque table in this
instruction manual.
Refer to the diagrams on the following pages for general component layout and for
general routing of power input, power output (motor connections), and control wiring for
your panel. Power input wiring should be routed away from power output wiring, and
both should enter the panel from separate conduit. Control wiring should be routed away
from power wiring, and should enter the panel from separate conduit. Knockouts are
provided on the Type 1 wall-mount panels. Floor-mount and NEMA 12 ventilated wall-
mount panels require holes to be drilled in the field. Refer to the panel outline drawing
provided for recommended conduit locations.
Refer to the following section Control Wiring for descriptions of the control connections.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Page 6 of 22
Advertisement
Table of Contents
