Transport And Start Up; Transport And Installation; Assembly; Mounting To Bench Or Stand - Jet JWSS-22B Operating Instructions Manual

Fig 2-1

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in closed rooms
and must be placed stable on firm and levelled
surface.
For safety reasons, the machine must be bolted to
the work bench or to the optional leg stand.
The base has four 9.5mm through hole (Fig 3).Four
3/8-16 UNC screws, washers and nuts are necessary
with the machine for a possible work bench mount.
Fig 3
For packing reasons the machine is not completely
assembled

5.2 Assembly

If you notice transport damage while unpacking, notify
your supplier immediately. Do not operate the
machine!
Dispose of the packing in an environmentally friendly
manner.
Clean all rust protected surfaces with a mild solvent.
Do NOT lift scroll saw beneath arm (Figure 4) which
may result in damage to linkage system. Always lift
using motor and edge of table (Figure 5).
Figure 4: INCORRECT lifting
Figure 5: correct lifting

5.3 Mounting to bench or stand

The scroll saw should be installed upon a sturdy, flat
surface with all four legs contacting the surface. Do
NOT install with saw partially hanging over edge of
table or workbench.
If scroll saw will not be bolted down to a surface,
install the four foot pads to reduce vibration. See
Figure 6. Lower hex nut may be adjusted for
height. Tighten top hex nut down against saw foot.
Figure 6: leveling foot
The preferred method is to mount the saw directly
to a solid workbench or table, or to the optional
JET stand. If mounting to a workbench, use a pad
(provided rubber washers) between saw and bench
to minimize vibration. See Figure 7.