Technical Data Of The Fidamat 6-G; Table 7-8 Technical Data - Climatic Conditions; Table 7-9 Technical Data - General - Siemens FIDAMAT 6-G Operating Instructions Manual

Electric in- and outputs
Analog inputs
Binary inputs
Serial interface
Options
Table 7-8
Climatic conditions
Permissible ambient temperature
Permissible humidity
See also
Dimension diagrams (Page 8-3)
7.2

Technical data of the FIDAMAT 6-G

Table 7-9
General information
Measurement ranges
Automatic measuring range switch
Smallest possible measuring span
Detection limit
Largest possible measuring span
Concentration units (ppm)
Measured value display
Digital display resolution
Used position
Conformity
Oven temperature
FIDAMAT 6-G
Operating instructions, 07/2006, A5E00478463
Technical data - climatic conditions
Technical data - General
7.2 Technical data of the FIDAMAT 6-G
2, laid out on 0/ 2/ 4 up to 20 mA for external
pressure sensor and carrier gas correction
(interference gas correction)
6, designed for 24 V, floating, can be freely
parameterized, e.g. for measuring range
switching
ELAN (RS 485)
AUTOCAL function with 8 additional binary inputs
and relay outputs each, also with PROFIBUS-PA
or PROFIBUS-DP
+5 °C to +45 °C in operation
-30 °C to +70 °C during storage and shipping;
< 90 % RH (RH = relative humidity) as an
average over the year, during storage and
shipping (no dropping below the dew point)
4, internally and externally switchable;
manual and automatic measuring range switch
possible
Hysteresis, selectable
0-10 ppm
0.03 ppm
99,999 ppm
C1, C3, C6, mg C/m3
Digital concentration display (5 digits with floating
decimal)
0.1 % of the measured value
Vertical front wall
CE marking EN 50081-1, EN 50082-2
Can be set to between 100-200 °C (depending on
the application)
Technical data
7-3