Authorized Personnel; Electric Shock Hazard - SKF MicroDosage System Assembly Instructions Manual

Assembly instructions
In particular, the described products are neither
designed nor approved for use in conjunction
with fluids of Group 1 (Dangerous Fluids) as
defined in Article 2, Para. 2 of Directive
67/548/EEC of June 27, 1967.
The described products are neither designed
nor approved for use in conjunction with gases,
liquefied gases, pressurized gases in solution,
vapors, or and such fluids whose vapor pres-
sure exceeds normal atmospheric pressure
(1013 mbar) by more than 0.5 bar at their
maximum permissible temperature.
Unless specially indicated otherwise, products
from SKF Lubrication Systems Germany GmbH
are not approved for use in potentially explosive
areas as defined in the ATEX Directive 94/9/EC.
1.2

Authorized personnel

Only qualified technical personnel may install,
operate, maintain, and repair the products
described in the assembly instructions.
Qualified technical personnel are persons who
have been trained, assigned, and instructed by
the operator of the final product into which
the described product is incorporated. Such
persons are familiar with the relevant stan-
dards, rules, accident prevention regulations,
and assembly conditions as a result of their
training, experience, and instruction. They are
qualified to carry out the required activities
and in doing so recognize and avoid any po-
tential hazards.
The definition of qualified personnel and the
prohibition against employing non-qualified
personnel are laid down in DIN VDE 0105 and
IEC 364.
Page 9
1.3

Electric shock hazard

Electrical connections for the described product
may only be established by qualified and
trained personnel authorized to do so by the
operator, and in observance of the local condi-
tions for connections and local regulations
(e.g., DIN, VDE). Serious injury or death and
property damage may result from improperly
connected products.
Danger!
Performing work on an energized
product may result in serious
injury or death.
Assembly, maintenance, and repair
work may only be performed on pro-
ducts that have been de-energized by
qualified technical personnel. The
supply voltage must be switched off
before opening any of the product's
components.
EN