SKF MicroDosage System Assembly Instructions Manual page 5

Table of contents
Operating instructions
Microdosage system (MDS)
1. Safety instructions
1.1 General information
1.2 Disclaimer of liability
2. Lubricants
3. Transport, delivery, and storage
3.1 Lubrication units
3.2 Electronic and electrical devices
3.3 General information on storage
4. Assembly
4.1 Information on assembly
4.2 Installation and use on spindles
4.2.1 Spindle design
4.2.2 Lubricant quantity
4.2.3 Filling lubricant ducts in the spindle
5. Design and function
5.1 General information42
5.2 Principle of the SKF microdosage system 43
35 6. Operation
6.1 General information
36 6.2 Microdosage system parameters
36 6.2.1 Configuring the system
36 6.2.2 Determining quantity of lubricant
6.3 Commissioning/venting the system
36 6.3.1 Venting the system
6.3.2 Filling spindle lubricant ducts
37 6.4 Calibration of the system
37 6.4.1 General
37 6.4.2 Manual calibration
37 6.5 External adjustment of volumetric flow
6.4.3 Automatic calibration
38
38 7. Shutdown and disposal
38 7.1 Temporary shutdown
38 7.2 Permanent shutdown
40
41 8. Maintenance and service
8.1 General information
42 8.2 Maintenance and repair
45 9. Malfunctions
45 9.1 General
46 9.2 Malfunctions, causes, and remedies
47 9.3 Questions and answers on using the
47 SKF microdosage system
48
48 10. Technical data
50 10.1 MDU micro-metering unit
51 10.2 MDR lubricant reservoir
51
11. Accessories
51
52
52
55
55
55
56
56
57
EN
Page 5
58
58
59
59
61
61
61
62