System Pressure Hazard; Compressed Air Hazard; Warranty And Liability - SKF MicroDosage System Assembly Instructions Manual

EN
Page 10
Note!
The MDU metering unit contains elec-
tronic components that can be destroy-
ed by accidental electrostatic charge or
discharge (ESD). To prevent possible da-
mage due to ESD, hands and any tools
must be discharged on a bare grounded
position on the installation site prior
to performing any work in the area of
the opened control unit's circuit board.
Conductors or component connections
within the device must not be touched
under any circumstances.
1.4

System pressure hazard

Danger!
Centralized lubrication systems are
pressurized during operation. Centralized
lubrication systems must therefore be
depressurized before starting assembly,
maintenance, or repair work, or any
system modifications or system repairs.
1.5

Compressed air hazard

The lubricant reservoir is pressurized with
compressed air.
Danger!
The described product is pressurized
during operation. The product must
therefore be depressurized before
starting assembly, maintenance or
repair work, or any system modifications
or system repairs.
Assembly instructions
1.6

Warranty and liability

SKF Lubrication Systems Germany GmbH as-
sumes no warranty or liability for the
following:
o Non-compliant usage
o Improper assembly, configuration, filling,
disassembly, or improper operation
o Use of unsuitable or contaminated lubricants
o Maintenance and repair work performed
improperly or not performed at all
o Use of non-original SKF components or
spare parts
o Alterations or modifications performed
without written approval from SKF
Lubrication Systems Germany GmbH
o Results of improper response to
malfunctions
o Independent modification of system
components
o Non-compliance with the instructions for
transport and storage