SKF MicroDosage System Assembly Instructions Manual page 64

951-170-217-EN
September 2014
The contents of this publication are the copyright of the publisher and may not be reproduced in
whole or in part without permission of SKF Lubrication Systems Germany GmbH. Every care has
been taken to ensure the accuracy of the information contained in this publication. However, no
liability can be accepted for any loss or damage, whether direct, indirect, or consequential, arising
out of use of the information contained herein.
All SKF products may be used only for their intended purpose as described in these assembly
instructions with associated operating instructions. If assembly/operating instructions are supplied
together with the products, they must be read and followed. Not all lubricants can be fed using
centralized lubrication systems. SKF can, on request, inspect the suitability of the lubricant se-
lected by the user for pumping in centralized lubrication systems. Lubrication systems and their
components manufactured by SKF are not approved for use in conjunction with gases, liquefied
gases, pressurized gases in solution, vapors, or such fluids whose vapor pressure exceeds normal
atmospheric pressure (1013 mbar) by more than 0.5 bar at their maximum permissible temper-
ature.
Particular attention is called to the fact that hazardous materials of any kind, especially the materials
classified as hazardous by EC Directive 67/548/EEC, Article 2, Para. 2, may only be filled into
SKF centralized lubrication systems and components and delivered and/or distributed with such
systems and components after consulting with and obtaining written approval from SKF.
SKF Lubrication Systems Germany GmbH
Motzener Strasse 35/37 ·12277 Berlin · Germany
PO Box 970444 · 12704 Berlin Germany
Tel. +49 (0)30 72002-0 · Fax +49 (0)30 72002-111
www.skf.com/lubrication
SKF Lubrication Systems Germany GmbH
2. Industriestrasse 4 · 68766 Hockenheim · Germany
Tel. +49 (0)62 05 27-0 · Fax +49 (0)62 05 27-101
www.skf.com/lubrication