Table Of Contents - SKF MicroDosage System Assembly Instructions Manual

EN
Page 4

Table of contents

Assembly instructions
MicroDosage System (MDS)
Service
Information concerning EC Declaration of
Conformity and EC Declaration of Incorporation
Explanation of symbols and signs
1. Safety instructions
1.1 Intended use
1.2 Authorized personnel
1.3 Electric shock hazard
1.4 System pressure hazard
1.5 Compressed air hazard
1.6 Warranty and liability
1.7 Existing residual risks
2. Lubricants
2.1 General information
2.2 Selection of lubricants
2.3 Approved lubricants
2.4 Lubricants and the environment
2.5 Lubricant hazards
1 3. Overview
3 3.1 SKF microdosage system
3.2 MDU micro-metering unit
6 3.3 MDR lubricant reservoir designs
7
4. Assembly
8 4.1 General information
8 4.2 Setup and attachment
9 4.2.1 General information on
9 lubrication line arrangement
10 4.3 MDR lubricant reservoir
10 4.3.1 Attachment of MDR lubricant reservoir
10 4.3.2 Assembly drawing with minimum
11 installation dimensions
4.3.3 Electrical fill level indicator
13 4.3.4 Initial filling and venting of the
13 MDR lubricant reservoir
13 4.3.5 Connecting compressed air connection
14 4.4 MDU micro-metering unit
15 4.4.1 Attachment of the MDU micro-
15 metering unit
16 4.4.2 Assembly drawing with minimum
16 installation dimensions
17 4.4.3 Capillary line connection
18 4.4.4 Arrangement of capillary lines
4.5 Main lubricant line and venting
19 4.5.1 Venting the main lubricant line
19 and MDU micro-metering unit
20 4.6 Note on the rating plate
4.6.1 MDU rating plate
20 4.6.2 MDR rating plate
21
22
22
23
23
25
26
26
Table of contents
27
29
30
30
31
33
33
33