Table of Contents
Advertisement
Software configuration
•
•
•
•
•
•
•
•
5.2
Connect the CSI 2600 to the network server
After configuring the CSI 2600 with an IP address on the same network as the Network
Server, connect to the network server through the Ethernet cable.
Procedure
1.
2.
5.3
Configuration overview
The CSI 2600 is a network-based system. The monitoring unit communicates with a server
through an Ethernet connection. In order for the unit and the server to successfully
communicate, both must have addresses known to each other. The addresses can be
46
-
adjustment of alarm levels
-
on-demand data acquisition
Online Configuration (O_config)—Program that allows the creation and modifying
of databases for use with the online system, along with system commissioning.
Vibration Analysis (Diagnostics)—Application that allows the user to request and
save transient data and view live streaming data. It provides a variety of analysis
functions necessary for analyzing the data generated by the CSI 2600.
CSIMtDbMgr Service—Handles most of the reading and writing operations
performed on databases stored on the server. It also indexes and verifies the
integrity of databases.
Online Server (O_server)—The central process service which handles all predictive
activity on the online system. It is responsible for processing requests from the
client, sending configuration information to the CSI 2600, and receiving data from
the CSI 2600.
MHM Remote—Service that handles transient data generated by the CSI 2600, and
database access required by the Vibration Analysis program.
CSI 2600—Hardware portion of the monitoring system; a portable unit that is
connected to the server through Ethernet.
IIS FTP—Microsoft's IIS includes an FTP server which needs to be installed to allow the
CSI 2600 to load firmware from the server.
Firmware—The firmware consists of two files which are loaded from the computer
during the boot up of the CSI 2600. This allows most system updates to be installed
on the computer like any other program update without the requirement of any
special interaction with the CSI 2600 beyond rebooting it to allow the new version to
load.
If you are using a computer, connect a standard Ethernet cable (included) to
connect the unit's Hub port to the computer.
If you need to connect to a Local Area Network to connect to the network server,
connect a standard Ethernet cable (included) to the unit's NIC port.
MHM-97453, Rev 1
Advertisement
Table of Contents
