Mounting Accelerometers - Emerson Machinery Health Expert CSI 2600 User Manual

4.8.4 Transient Filter Board
The Transient Filter Board provides parallel anti-aliasing filters for the signal channels on
the Signal Input module. Either one or two Transient Filter Boards may be used to
configure either a 12- or 24-channel Transient System.
When installing the Transient Filter Board on the Signal Input module, make sure both
mating connectors are fully engaged, then install all six mounting screws.
Figure 4-7:
A.
B.
C.
4.9

Mounting accelerometers

4.9.1 Handling accelerometers
General purpose accelerometers are susceptible to mechanical shock. Take precaution
when handling sensors. When magnetically mounting sensors, it is possible to generate
shock loads that will damage sensors and void the manufacturer's warranty. To prevent
damage, gently rock magnetic sensors into place.
WARNING!
Do not drop, hammer, or impact the sensor housing before, during, or after installation.
MHM-97453, Rev 1
Transient Filter Board PCB mounted on a Signal Input module
Mounting screw positions
Transient Filter Board
I/O relay DIP switches
Hardware configuration: overview
33