Emerson Machinery Health Expert CSI 2600 User Manual page 58

Software configuration
Table 5-4:
Key sequence
Enter
. (period)
– (dash)
Ctrl + B
Ctrl + T
reboot (case sensitive)
5.7.2 HyperTerminal navigation after boot interrupt
You may interrupt the boot process by immediately pressing Space after the VxWorks
copyright is displayed. If you interrupt the boot process, use the following commands to
navigate the boot configuration console.
The most commonly used commands are ?, @, P, and C.
Note
When modifying an entry, type the new setting. Do not attempt to backspace over an existing entry.
CAUTION!
Use only the first four commands (?, @, P, C) in
before using the other commands.
Table 5-5:
Command
?
@
P
C
g adrs
d adrs[,n]
z adrs
f adrs, nbytes, value
t adrs, adrs, nbytes
e
n netif
54
HyperTerminal navigation commands
Description
Accept the value.
Clear the value when you press the period key followed by Enter.
Go back to the previous parameter when you press dash followed
by Enter.
Toggle between Main Processor and Transient Processor.
Display/hide label that identifies the processor producing output to
the screen.
Reboot the board with new boot settings.
Boot interrupt navigation commands
Description
Print this list
Continue boot (load and go)
Print boot parameters
Change boot parameters
Go to adrs
Display memory
Modify memory
Fill memory
Copy memory
Print fatal exception
Network interface device address and other important information
Table 5-5. Contact Emerson Product Support
MHM-97453, Rev 1