Emerson Machinery Health Expert CSI 2600 User Manual page 57

If allowed to complete without interruption, the boot process should finish with a screen
similar to this:
Figure 5-6:
5.7.1 HyperTerminal navigation after boot complete
After typing bootChange in a HyperTerminal session, use the following commands to
navigate:
Note
When modifying an entry, type the new setting. Do not attempt to backspace over an existing entry.
MHM-97453, Rev 1
Figure 5-5: Transient Processor boot parameters
Note
Only change boot flags under the direction of Emerson Product Support.
HyperTerminal Boot Complete screen
Software configuration
53