Changing The Coolant; Anti Freeze - Zetor UTILIX CL Operator's Manual

Changing the coolant

1 - Radiator cap
1. Open the drain cock in front of the engine oil filter to
drain the coolant.
1 - Drain Cock
2. Open the radiator cap at the same time.
3. To give a thorough clean run a hose into the radiator
and flush it out.
4. Close the drain cock and refill the radiator with
a coolant mixture of water and corrosion inhibitor or anti
freeze.
5. Start the engine and allow it to run for approx
5 minutes, check the water level again and top up if
required.
Caution:
Do not remove the radiator cap on a hot engine.
Allow the engine to cool down and then turn the cap slowly to ensure, that there is no excessive
pressure in the radiator.
Caution:
Serious burns, can result from the contents of pressurized, hot radiators.
Allow the engine to cool down completely before opening radiator cap.

Anti freeze

Frozen cooling water can damage the engine.
Before replacing the anti freeze solution flush the radiator.
Mix the anti freeze solution in accordance with the instructions applicable to the brand of anti freeze and the
locals climate.
Replace the solution in the radiator.
In case of loss of solution due to evaporation or overflow, replace with the original mixture ratio.
CONTROLS, INSTRUMENTS & OPERATIONS
94
U18N084
U18N085