Seat Sliding; Seat Back Reclining - Zetor UTILIX CL Operator's Manual

ROPS (ROLL OVER PROTECTION STRUCTURES)

Seat sliding

1 - Forward/Backward adjustment lever
Before operating a Tractor it is important to adjust the seat to the most comfortable position & check whether
it is properly locked in its position. Figure 1 identifies the seat fitted to your Tractor.
NOTE: Do not use solvents to clean the seat. Use warm water with a little detergent added.
Caution: Do not put a hand between the seat and the slides when adjusting the seat position.
You can get injured unexpectedly.
To select seat position, move adjusting lever and slide seat closer to or away from dash panel and controls.
Danger: Check whether the seat properly locked in its position before driving the tractor.
Danger: Always use the seat belt when the ROPS is installed. Do not use the seat belt if
a foldable ROPS is down or there is no ROPS. Check the seat belt regularly and replace if frayed or
damaged.

Seat back reclining

1 - Seat belt
2 - Seat back angle adjustment lever
To change the seatback angle, raise the lever on the left of the seat.
Then, adjust the seatback angle with the lever pulled. Release the lever after adjustment. Make sure that the
lever is returned and the seat is firmly fixed after adjustment.
14
UCL18N004
UCL18N005