Ventilation; Re-Circulation Inlets Fully Closed; Working Lamp Switch; Wiper Control Switch - Zetor UTILIX CL Operator's Manual

Ventilation

The ventilation unit is housed in the cab ceiling.
To switch it on and adjust it, turn the electrical fan switch to the desired speed.
The cab becomes slightly pressurized when the ventilation system is in operation, so that the fresh air can
enter only by way of the filter installed in the rear section of the cab roof.
The fan switch can be operated only after the ignition key is inserted.
The air flow can be regulated and directed by suitable positioning the air diffusers.
Air can be taken in fresh from outside or recirculated from within the cab by way of the relative side inlets.

Re-circulation inlets fully closed

Air is taken in entirely from outside the cab through the rear grille and filtered through a paper element
positioned behind the grille.
Note: It is very important that the air diffusers never be completed closed so as to allow for a steady air flow.
To obtain a greater pressurization inside the cab, it is necessary to take the air from the outside, therefore
the inside air recirculation grille should be fully closed.

Working lamp switch

The front and rear working lights are ON when push the button. The work light indicator lamp on the
instrument cluster will illuminate.
1 - Wiper switch
2 - Washer switch
3 - Working lamp switch

Wiper control switch

On switch
Wind screen wiper operation.
Continuous pushing button operates wiper and washer pump.
Off switch
Wind screen wiper ''Off'' and operates washer pump.

Windscreen washer tank

Check the level of windscreen washer fluid in the plastic reservoir located on the rear side of tractor. During
winter it is advisable to add a suitable antifreeze or methyl alcohol to the windscreen washer fluid.
1 - Washer tank
CABIN
111
U18N113
U18N114