Air Conditioner Compressor Belt Adjustment; Servicing The Air Cleaner - Zetor UTILIX CL Operator's Manual

Air conditioner compressor belt adjustment

1 - Tension adjusting bolt
Check the compressor belt tension regularly and adjust if
required.
The correct tension is if the center of the belt is pushed
with a finger it moves in approx. 0.39 in. (10 mm) as
shown in the picture.
To adjust the belt, loosen the nut (1,2,3) on the tension
blot, move the alternator to the desired position and
tighten the nut (3,2,1).
Also ensure that the bottom alternator bolts are tighten.

Servicing the air cleaner

1 - Air cleaner body
2 - Element
3 - Cover
To remove the dust from the evacuator valve squeeze it between thumb and fingers to let excess dust out
and wipe around the valve to keep it clean from outside.
To clean the main element, remove the left side cover.
Remove the element by unloading the wing nut.
Remove dust by blowing it out of the element with compressed air. Check the element to ensure it is not
damaged. Reassemble the element.
Important:
Never beat the element on a stone or concrete floor/wall to clean it.
Check all connections and hoses especially on the clean side of the air cleaner to ensure no dusty
air can enter the engine. Check the element for flaws by putting a light inside the element.
When reassembling make sure all surfaces seal correctly to keep dust out.
When working in dusty conditions increase the service frequency.
- Replace the element after cleaning it 5 times or it is damaged.
CONTROLS, INSTRUMENTS & OPERATIONS
100
U18N098
U18N099