Table Of Contents - Steelcase 5 Series Manual

®

TABLE OF CONTENTS:

Lets Get Started!.........................................................................................................
Which Legs Go Where?..............................................................................................
Determine Leg Positions on your Table......................................................................
Overhangs and Custom Leg Positions.......................................................................
Mounting Legs to Worksurfaces.................................................................................
Determine Switch Position on your Table...................................................................
o
Corner Tables.......................................................................................................
90
Left-Hand Tables.........................................................................................................
o
For 90 Tables.............................................................................................................
o
For 120 Tables...........................................................................................................
Identify the Primary and Secondary Motors..........................................................................
Installing Motors and Synchronizing Legs...................................................................
Driveshafts and Leg Synchronization..........................................................................
Installing Driveshafts...................................................................................................
Installing Switch & Power Supply................................................................................
Attach Driveshaft Covers and Wire Managers............................................................
Installing Stretchers....................................................................................................
Connect and Route All Cables....................................................................................
Finishing the Table Assembly......................................................................................
Appendix A: 2-Piece Worksurface Assembly..............................................................
Appendix B: Installing a Keyboard Mechanism for Bi-Level Worksurfaces................
Overview of Assembly Process
1) Decide on the table configuration.
2) Assemble 2-piece worksurface or bi-level mechanism (if applicable).
3) Attach legs to worksurface (with worksurface upside-down).
4) Assemble motors, power supply, and gearbox (if applicable).
5) Synchronize legs and add driveshaft(s).
6) Add stretcher(s) and decorative parts.
7) Add driveshaft cover(s) and wire manager(s).
8) Connect and route all cables, mount switch.
9) Flip table upright and test function.
10) Level and clean it up.
11) PLEASE LEAVE THESE INSTRUCTIONS, AND THE USER GUIDE,
IN AN OBVIOUS PLACE FOR THE END USER AFTER ASSEMBLY.
PAGE(S):
6
7
8
8
9
10
11
12
13
13
14
15
15
16 through 19
20
21
22 & 23
24
25
26 & 27
28 through 34
Page 6 of 35
004231D Rev T