Package Contents; Assembling Return Unit End Panel To Top; Attaching Back Panel - Steelcase Machine and Typewriter unit 41-ATT Assembly Directions

QTY.
1
1
1
1
1
1
4
2
4
1
1
2
2
3
2
1
1
2
NOTES:
1. The following assembly steps apply to either a right or left hand 41-ATT unit. A left hand unit is shown for all instructions.
2. A steel top has been shown. When assembling a wood top, the same instructions apply.
3. If the unit is assembled on a non-carpeted floor, we recommend you cushion the top with cardboard.
4. If your unit has been pre-assembled, begin with Step 4.
1.

ASSEMBLING RETURN UNIT END PANEL TO TOP

Place end panel over pre-drilled holes in end of top
and install (2) 1/4 x 1" hex head screws.
NOTE: Use (2) channel spacers when attaching an end panel
to a 4200 top.
CHANNEL SPACERS
4200 ONLY
Assembly Directions
93-9500974 REV A

PACKAGE CONTENTS

DESCRIPTION
TOP
BACK PANEL
END PANEL & LEG ASSEMBLY
BOTTOM PANEL PLATE (FIG. C)
BOTTOM PANEL PLATE (FIG. D)
MOUNTING BRACKET
#10-24 HEX NUTS
#10-24 X 3/8" MACHINE SCREWS
1/4 X 1" HEX HEAD SCREWS (6 REQUIRED FOR WOOD TOP)
HANGER BRACKET
TWIN SPEEDNUT
CLIP ANGLE (NOT REQUIRED FOR WOOD TOP)
1/4-20 X 1-1/4" ROUND HEAD MACHINE SCREW (NOT REQUIRED FOR WOOD TOP)
#10 X 1/2" SHEETMETAL SCREW
#10 X 1/2" HEX HEAD SCREW
SLOPE TRAY ASSEMBLY
TYPE PAD
CHANNEL SPACERS (USED ON 4200 ONLY)
2.

ATTACHING BACK PANEL

Fasten back panel to top with (3) #10 x 1/2"
sheetmetal screws. Before tightening screws be
sure to have a 3/32" overhang between the back
panel and end of top.
NOTE: Use (3) "Z" brackets when attaching back panel
to a 4200 top.
Z BRACKET
4200 ONLY
3/32"
Page
2 of 6