Installing Motors And Synchronizing Legs; Driveshafts And Leg Synchronization - Steelcase 5 Series Manual

®
1
Determine on which side of the table
each motor will go. (see page 8)
Install M6 x 80 bolts & M6 nuts to
each motor as shown.
Example: Primary motor and switch
on user's right-hand side.
2
Insert the exposed stud from each motor
through the spacer, and then into the side
mounting slot of the outboard leg mounting
plates. Install M6 nut, but DO NOT TIGHTEN
(leave motor loose).
NOTE: Install motors to outboard legs on 3-leg
tables. Do not install a motor to the center leg.
SPACER
M6 NUT

Installing Motors and Synchronizing Legs

Primary Motor
1
M6 NUT
(Equal-Sized or
Right-Hand Table
Shown This View)
2
EXPOSED STUD
MOTOR
Secondary Motor
M6 x 80 BOLT
NO MOTOR

Driveshafts and Leg Synchronization

Series 5 legs and motors must be synchronized
before installing the driveshafts.
Series 5 motors are shipped from the factory in the
"all the way down" position.
Before inserting the driveshafts, ensure ALL LEGS
are pushed all the way down (fully compressed).
MOTOR
Page 16 of 35
004231D Rev T