Through - Steelcase 5 Series Manual

®
Motor Placement on Rectangular Bi-Level
Tables with 2-Leg Base:
Rectangular bi-level table must still have the
motors mounted in between the legs.
For all bi-level tables, the switch and master
motor must be mounted on the user's right-hand
side. This is because the mechanism actuator
must be mounted on the left-hand side and
can't be moved.
o
Motor Placement on 90 Small-Corner Bi-Level
Tables with 2-Leg Base:
To allow space for the bi-level mechanism, the
o
motors on all 90 small-corner bi-level with a
2-leg base must be mounted outboard of the
legs as shown.
Appendix B: Installing a Keyboard
Mechanism for Bi-Level Worksurfaces (cont.)
Rectangular Bi-Levels:
ACTUATOR
SECONDARY MOTOR
(INBOARD)
o
90 Small-Corner Bi-Levels:
ACTUATOR
SECONDARY MOTOR
(OUTBOARD)
NOTE: For 90
base only. The cosmetic caps that cover the ends of
the driveshafts are not used and may be discarded.
SWITCH
PRIMARY MOTOR
(INBOARD)
NOTE: For 90
2-leg base only. Apply cap nut to the end of the
driveshaft as it protrudes from the motor.
SWITCH
PRIMARY MOTOR
(OUTBOARD)
For Compression Nut Version:
o
small-corner bi-level tables with 2-leg
For Cap Nut / Push Nut Version:
o
small-corner bi-level tables with
Page 35 of 35
004231D Rev T