Determine Leg Positions On Your Table; Overhangs And Custom Leg Positions - Steelcase 5 Series Manual

®

Determine Leg Positions on your Table:

• Many Series 5 tables allow multiple leg postions, providing flexibility to
maximize leg space, and allow overhangs for CPU slings and mobile
pedestal placement.
• The smallest tables may not allow for larger worksurface overhangs.
(The standard overhang is 1-1/4".)
• The mid-size tables may allow for a single 15" overhang.
• The largest tables may be capable of allowing dual 15" overhangs.
(One on each side.)
• Refer to the specification guide for the capabilities of your specific table.
NO OVERHANGS
LEFT-HAND OVERHANG
Legs may be mounted on the worksurface
in locations other than the factory default,
provided that:
• The overhangs DO NOT exceed 15".
• All screws are at least 1" from outside edges.
• All provided components still fit together (stretchers, driveshafts).
• No safety hazards are posed to the end users or installers.

Overhangs and Custom Leg Positions:

• There are pilot holes in worksurfaces that result in the standard
CABLE
PINCH-POINT
CLEARANCE
RIGHT-HAND OVERHANG
1.769"
(NO CABLE / PINCH-POINT
CLEARANCE, BACK OF
FOOT FLUSH WITH BACK
OF WORKSURACE)
overhangs (1-1/4" and 15"), as well as a clearance at the back to
avoid pinch-points and provide for cable drop.
1"
Side View:
AND
9"
CUSTOM
OVERHANG
Front View:
1-1/4"
OVERHANG
Standard Mounting Plate Positions:
(Bottom View)
Front of Wksf. Front of Wksf.
(User Edge) (User Edge)
Back of Wksf.
Back of Wksf.
1-1/4"
OVERHANG
OVERHANG
0.769"
OFFSET
004231D Rev T
15"
15"
0.769"
OFFSET
Page 9 of 35