Installing Stretchers - Steelcase 5 Series Manual

®
1
Sub-assemble stretchers as shown. For 90
stretcher, place the decorative cover over the
small tube first, then insert into large tube.
NOTE: Wherever possible, ensure that the set
screws face the floor after table is assembled
and flipped upright.
Straight:
1
90º:

Installing Stretchers

o
SET SCREWS TO
FACE THE FLOOR.
NOTE: On 3-leg tables, be sure to use the correct length
of stretcher for the particular side of the worksurface.
Use longer components on the long side and shorter
components on the short side, where applicable.
(Equal-Sized or
Right-Hand Table
Shown This View)
Page 23 of 35
004231D Rev T