Mounting Legs To Worksurfaces - Steelcase 5 Series Manual

®

Mounting Legs to Worksurfaces

CAUTION: All holes in the leg mounting plates MUST
Mounting Plate
Raise leg all the way up.
be filled with screws. Failure to install all
screws may result in structural instability.
Worksurface
Pilot Holes
= PILOT HOLE
= NO PILOT HOLE PROVIDED
Raising leg allows access to the screws
adjacent to the inner column.
FOR EASIER
ACCESS
NOTCH IS ALWAYS
AT BACK OF LEG
(BACK OF TABLE)
Align each leg with the pilot holes in the desired
location, in the correct orientation. Attach each
leg with ten (10) of the provided #10 x 1.075 long
screws. These screws have a special drill-point,
making them easy to drive in without a pilot hole.
See step 10 on Page 18 for additional considerations
before finalizing the mounting of the legs.
FOR EASIER
ACCESS
Page 10 of 35
004231D Rev T