For 90 O Tables; For 120 O Tables - Steelcase 5 Series Manual

®

For 90 o Tables

Attach the intermediate gearbox to the center leg using the
hardware provided. Refer to note below and use spacer and
30 mm bolt as required.
(Equal-Sized or
Right-Hand Tables
WITHOUT SPACER & 30mm BOLT
NOTE: Some configurations of 90 degree tables may not
allow for proper driveshaft-to-gearbox alignment while
using short (16mm) bolt. For this condition, use longer
(30mm) bolt and spacer as shown.
TOP VIEW
16mm
BOLT
WRONG
ALIGNMENT!
WITH SPACER & 30mm BOLT
SPACER
30mm BOLT
CORRECT
ALIGNMENT!

For 120 o Tables

In the center leg, insert the short (4") driveshaft,
and attach a universal joint to each end. Tighten
set screws on the universal joints with the
provided hex wrench.
UNIVERSAL JOINT
4" DRIVESHAFT
UNIVERSAL JOINT
Page 14 of 35
004231D Rev T