Attach Driveshaft Covers And Wire Managers - Steelcase 5 Series Manual

®
1
Determine which driveshaft cover goes where, if
applicable. Attach driveshaft covers using four (4)
screws each, into the pre-drilled pilot holes.
~
1/4"
DRIVESHAFT
ROUTE SWITCH CABLE
COVER
THROUGH THIS AREA
MOTOR
2
To maximize available space on the back of the
worksurface for clamping accessories, place the
wire manager over the driveshaft cover as shown.
Attach with either two (2) or three (3) screws.
No pilot holes are provided for wire managers.
Attach Driveshaft Covers and
Wire Managers
NOTE: There should be about 1/4" between the
motors and the driveshaft covers.
ALIGN HOLES IN COVER
WITH PILOT HOLES IN
WORKSURFACE.
WIRE MANAGER IS
PUSHED UP AGAINST
DRIVESHAFT COVER.
BACK OF
WORKSURFACE
2
TWO SCREWS
PER SIDE
1b
LONG COVER
1a
(Equal-Sized or
Right-Hand Table
Shown This View)
WIRE MANAGER
004231D Rev T
SHORT COVER
Page 22 of 35