Table of Contents
Advertisement
STAGE Screen
2)
Switching between functions
Each time the SHIFT button is pressed, F1 to F10 switches to F11 to F20 and back again.
(F1 - F10)
F1
F
2
R
(F11 - F20)
#
CH lay
#
1/3
3.
How to Operate the STAGE Screen
Apart from the procedures described below, operation is the same as for the BLIND screen. Refer to the
description of how to operate the BLIND screen.
1)
Recording the screen contents
(1) Overwrite-record the CUE number that was called onto the screen.
> ↵ OK? ↵
Example) Overwrite-record on CUE1.
> ↵ ↵
(2) Record a CUE with a different CUE number.
* When an ACTUAL CUE is recorded with a different number, that CUE number switches to the
ACTUAL CUE.
> CUE CUE number ↵
Example) Record the ACTUAL CUE as CUE 1.5.
> CUE 1 . 5 ↵
If the CUE is already recorded, a confirmation message asking you whether you want to overwrite
is displayed.
2)
SHOOTING mode
Press the F3 (SHOOT) button, and the SHOOTING mode is entered.
Select a channel. When the level lights up, the CUE LED goes out and only the specified channel stays
lit.
Press the F3 (STAGE) button again, and the ACTUAL CUE lights up again.
(1) Specify a channel and light it at the specified level.
> CH number @ Level
Example) Light CH1 at 50% level.
> 1 @ 5 0
(2) Specify a channel and light it using the level wheel.
> CH number @ Level wheel
Example 1) Raise the level of CH1.
> 1 @ Rotate the level wheel upward.
(3) Light the next (+1) channel. The channel immediately before the NEXT operation goes out.
The level of lighting remains unchanged from that specified before.
> NEXT
3
SHOOT
4
DATA
5
#
ALL/PT
#
DspMod
#
6
7
NXTODR
#
HEATUP
#
13-2
8
9
SelEdt
#
< Page
#
Page >
CL
#
#
Advertisement
Table of Contents
