Toshiba LICSTAR-IV SE Instruction Manual page 139

PATCH Screen
3) Switching the display data
Each time the F5 (DSPmod) button is pressed, the data displayed on the screen switches from Patch
to NDM and then to Proportional level.
The name of the data being displayed is at the upper right of the screen.
PATCH : CH PATCH is displayed.
NDM : NDM setting status is displayed.
Prop.@ : The proportional level setting status is displayed.
4) Determining input procedure
Select the mode to enter from a CH or a dimmer.
The selected entry mode is displayed at the upper right of the screen.
DIM -> CH : Entry mode from a dimmer
CH -> DIM : Entry mode from a CH
> F8 (PATmod)
This operation switches the enter mode from "DIM -> CH" to "CH -> DIM" and back again.
Pressing the F1 (CH) or F2 (DIM) button allows you to enter data independently of this mode.
5) How to enter dimmer names
* Refer to the attached sheet "How to enter dimmer names."
6) How to enter dimmer names using the mouse
Click the left mouse button on a dimmer displayed on the DIM PATCH or EX DIM PATCH screen. The
name of that is displayed in the command line.
Click the right mouse button and all the selected dimmers are canceled.
7) Assigning specified dimmer(s) to a CH
> F2 (DIM) Dimmer name(s) = CH number ↵
If the specified CH does not have the specified dimmer assigned, press the ↵ button once to assign
the dimmer to the CH.
If the specified CH already has the specified dimmer assigned, press the ↵ button twice to assign the
dimmer to the CH.
Example) Assign 2S1 to CH1.
> DIM 2S1 = CH1 ↵
↵
21-3