Table of Contents
Advertisement
EFFECT PANEL
5.2) Deleting a step from the submaster
Operating procedure
(1) Press the EDIT button above the submaster fader to enter edit mode.
The EDIT button above the submaster fader flashes and the effect assigned to
this submaster is called to the EFFECT PANEL.
After this point the operation will be performed on the EFFECT PANEL.
The EDIT button on the EFFECT PANEL also flashes.
[Press the EDIT button again and the EDIT button goes out and edit mode ends.]
(2) Press the GO/STOP button to stop the effect.
The STEP number where the performance has stopped is displayed on the STEP
number indicator.
At this time, the STEP button lights up.
(3) Press the
(4) Delete the step. Make sure that the STEP button is lit.
Press the DEL button.
1)
The DEL button lights up and the STEP button flashes.
2) Press the REC button.
When the REC button is pressed, the DEL button goes out and the step is
deleted.
To stop the step deletion, press the EDIT button.
In this case, edit mode is not entered.
Pressing the DEL button again while it is lit makes the DEL button go out and
cancels the deletion request.
[DEL button LED display status]
ON
: Confirming step or pattern deletion
or
button to select the STEP number to be deleted.
5-8
Advertisement
Table of Contents
