Table of Contents
Advertisement
Troubleshooting: Recovering Procedures
Recovery Procedure C: Switching the MAIN CPU
(1) When actual lights need to be held during actual performance or on other occasions, turn ON the
LEVEL HOLD button on the LIGHTING SYSTEM OPERATION PANEL.
The lighting controlled by the DIMMER CABINET is held.
(2) After checking how CUEs, SMs, EFFECTs, etc. are played back, press the CPU1/CPU2 (CONTROL
CONSOLE) button on the CONTROL PANEL to switch the CPU.
When the LEVEL HOLD button is turned ON, the lighting controlled by the DIMMER CABINET is held
and it remains unchanged.
(3) When the LEVEL HOLD is kept ON after the CONSOLE becomes operational, adjust the playback
state on the CONSOLE to the levels held by the LEVEL HOLD, and then release the LEVEL HOLD.
Crossfade occurs from the lighting held by the LEVEL HOLD to the CONSOLE output.
* If the CONSOLE remains inoperable even after the CPU was switched, an error condition may have
occurred in both of the two MAIN CPUs.
In this case, carry out
Recovery Procedure
A.
46-8
Advertisement
Table of Contents
