Honda V65 Magna-VF1100C 1983 Shop Manual page 75

7. Adjust the idle speed with the throttle stop
screw.
8. Turn the No. 1 carburetor pilot screw in until
the engine speed drops 50 rpm.
9. Turn the No. 1 carburetor pilot screw 1 turn
out from the position obtained in step 8.
10. Adjust the idle speed with the throttle stop
screw.
11. Perform steps 8, 9 and 10 for the No.2, 3 and
4 carburetor pilot screws.
12. Drive new pilot screw plugs into the pilot screw
bores with a 7 mm valve guide driver (P/N 07942
-8230000). When fully seated the plug surfaces
will be recessed 1 mm into the pilot screw bore.
FUEL TANK
Do not allow flames or sparks near gasoline.
Wipe up spilled gasoline at once.
Check the vent hole of the filler cap for blockage.
Check that fuel is flowing out of the fuel valve
freely. If fuel flow is restricted, clean the fuel
strainer.
Make sure that there are no fuel leaks.
AUXILIARY FUEL TANK
Drain fuel from the main and auxiliary tank.
Remove the seat, main fuel tank, and side covers.
Remove the regulator/rectifier.
Disconnect the battery negative cable, then positive
cable and remove the battery.
Remove the rear wheel (page 16 -3) .
Remove rear fenders A and B.
Detach the auxiliary fuel tank hose from the fuel
pump.
Disconnect the fuel level sensor wire terminals.
Remove the auxiliary fuel tank mounting bolt and
tank.
Install the auxiliary fuel tank in the reverse order of
removal.
FUEL SYSTEM
AUXILIARY
FUEL TANK
MOUNTING BOLT
LEVEL SENSOR REGULATOR/RECTIFIER
4-17