Honda V65 Magna-VF1100C 1983 Shop Manual page 290

PIVOT BEARING REPLACEMENT
Remove the dust seals and bearings from both
sides of the swingarm as follows:
Remove the swingarm bearings using the bearing
remover,
97936-8890300,
handle,
07936-
3710100,
and weight,
07936-3710200.
Install the
remover and expand it as much as possible behind
the bearing race. Strike the weight lightly several
times to move the race out enough so that the
remover can be expanded completely. Slide the
weight again with enough force to remove the race.
INSTALLATION
NOTE:
Replace the inner and outer bearing races as
a set. Replace the grease retainer plate when-
ever it is removed.
Install new grease retainer plates. Drive new outer
bearing races into the swingarm.
Apply grease to the pivot bearings, dust seals, and
pivot bolt tips.
Install the bearings and dust seals.
REMOVER HANDLE
07936-371 01 00
DRIVER
07749-0010000
REAR WHEEL/SUSPENSION
REMOVER WEIGHT
2710200
ATTACHMENT,
37
x
40
mm
07746- 0010200
\
BEARINGS
!.,
RIGHT PIVOT BOLT
DUST SEALS
LEFT PIVOT BOLT
16-15