Honda V65 Magna-VF1100C 1983 Shop Manual page 4

1. GENERAL INFORMATION
~~ENERAL
SAFETY
- - - - - - -
1-1
SERVICE RULES
1- 1
MODEL IDENTIFICATION
1-2
SPECIFICATIONS 1-3
TORQUE VALUES
1-5
TOOLS
1-7
CABLE & HARNESS ROUTING 1-9
EMISSION CONTROL SYSTEM 1- 17
-
......
·-
·----·
GENERAL SAFETY
IM·Wi@J
If the engine must be running to do some work, make sure
the art'a is Wt'/I·Vt'ntilated. Never run the engine in a closed
area. The exluJust contains poisonous carbon monoxidt'
gas.
l '?ttt.l;W@i
Gasoline is extremt>ly flammable and is explolive under
certain conditions. Do not Jmoke or allow flames or sparks
in your working area.
SERVICE RULES
t?d- M !Jml
The batrery electroly te contains sulfuric acid. Protect your
eyes, skin , and clothinx. Jn case of contacr, flush thorough·
~v with water and call a tloctor ij' elearo~vte gns in _vour
t:res.
1£1- Wi@l
The bouery generates hydrogen gas which can
be
highly
explosive. Do not smoke or allow flames or sparks near the
barury, especia/ly while charging
it.
1. Use genuine HONDA or HONDA-recommended parts and lubricants or their equivalent. Parts that do not meet HONDA's
design specifications may damage the motorcycle.
2 . Use the special tools designed for this product.
3. Use only metric tools when servicing this motorcycle. Metric bolts, nuts, and screws are not interchangeable with English
fasteners . The use of incorrect tools and fasteners may damage the motorcycle.
4 . Install new gaskets, 0 -rings, cotter pins, lock plates, etc. when reassembli ng.
5. When t ighte ning bolts o r nuts, begin with large r-diameter or in ner bolts f irst, and tighten to the specif ied to rque diagonally,
u n less a part icular sequence is specified.
6. Clean parts in cleaning solvent upon d isassembly. Lubricate any sliding surfaces before reassembly.
7. Aftu feassembly , check all paru for pfoper installation and operation.
8. Ro ute all e lec trical wires
as
shown on pages 1-9 th ro ugh 1·16 Cable and Ha rness Ro uting.
1-1
Ill