DISASSEMBLY
Remove the rubber cover.
Remove the snap
ring
with snap ring pliers (07914-
3230001) and remove the
push
rod from the master
cylinder.
Remove the master p
iston,
primary cup, and
spring.
It
may be necessary to apply a small amount of air
pressure to the fluid outlet to remove the master
piston and primary cup.
Clean all parts with brake fluid.
REAR
MASTER CYLINDER I.D.
INSPECTION
Measure
the inside diameter of the master cylinder
bore.
SERVICE
LIMIT
:
14.005 mm
(0.5533 in)
Check
for scores, scratches, or nicks.
HYDRAULIC BRAKES
SNAP
RING
MASTER CYLINDER BODY
PISTON
PRIMARY
CUP AND SPRING
PUSH ROD
17-15