Honda V65 Magna-VF1100C 1983 Shop Manual page 250

FRONT WHEEL/SUSPENSION
WHEEL INSPECTION
Check the rim runout by placing the wheel in a
truing stand. Turn the wheel slowly and read the
runout using a dial indicator.
SERVICE LIMITS:
RADIAL RUNOUT: 2.0
mm
(0.08
in)
AXIAL RUNOUT: 2.0
mm
(0.08
in)
NOTE :
The wheel cannot be repaired and must be
replaced with a new one if the service limits
are exceeded.
AXLE INSPECTION
Set the axle in V blocks and measure the runout.
SERVICE LIMIT: 0.2 mm (0.01 in)
WHEEL BEAR ING INSPECTION
Turn the inner race of each bearing with your
f inger. The bearings should turn smoothly and
quietly. Also check that the bearing outer race fits
tightly 1n the hub.
Remove and discard the bearings if the races do not
turn smoothly, queitly, or if they fit loosely in the
hub.
NOTE :
~lace
hub bearings in pairs.
Pack new bearings with grease and install them into
the hub with the special tools.
For bearing replacement, see page 1 5-22.
15-20