Honda V65 Magna-VF1100C 1983 Shop Manual page 183

Coat the rod small end with molybdenum disulfide
grease.
Assemble the pistons and connecting rods with the
pistons and piston clips as follows.
Front cylinder connecting rod and piston assembly.
Note that the front cylinder connecting rods are
marked MB4-F.
Install the pistons on the front connecting rods so
that the intake "IN" mark is facing opposite the oil
hole in the rod.
Rear cylinder connecting rod and piston assembly.
Note that the rear cylinder connecting rods are
marked MB4-R.
Install the pistons on the rear rods so that the intake
"IN" mark is facing the same direction as the oil
hole in the rod.
NOTE:
Do not interchange the pistons, piston
pins, or connecting rods.
Make sure that the p1ston pin clips are
properly seated.
Align the hole in the connecting rod bearing insert
with the hole in the connecting rod and instal l the
insert.
CRAN KSHA FT/ PI STON
FRONT CYLINDER "MB4-F" MARK
"IN" MARK OIL HOLE
REAR CYLINDER "MB4·R" MARK
OIL OLE "IN" MARK
OIL HOLES
12-13