Status Indicators On Receiver Module - ADS-tec OPC8017 Instruction Manual

OPC8017 OPC8024 / OPD8017 OPD8024

6.5.2 Status indicators on receiver module

The transmitter module has LEDs which indicate the status of the transmitter. They provide
information about the graphics link (HDCP), the power supply (PWR), the firmware (FW) and the
HDBaseT™ connection (HDBT).
The table below lists the various states.
Figure 21: Status indicators on receiver module
Signal
PWR
On (blue)
Off
FW
Flashing
Off
HDBT
On
Flashing slowly
Flashing rapidly
Off
HDCP
Flashing
Off
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
Action
The device is supplied with voltage via POWER
and is ready for operation
No power supply
Firmware is loaded and ready for operation
No firmware action
HDBaseT™ link present
Low Power Mode
Ethernet Fallback Mode
No link
Graphics link is present
No graphics link
39