OPC8017 OPC8024 / OPD8017 OPD8024
4.2 Installing device
Carefully insert the device from the front into the installation location.
Figure 5: Inserting device into installation location
Insert the clamping blocks into the openings as shown in the drawing.
Figure 6: Positioning clamping blocks
Slide the clamping blocks from the wide part of the opening into the narrow part.
Tighten the clamping blocks using the threaded pins.
o
Tighten the threaded pins only slightly at first.
o
Always tighten clamping blocks positioned furthest apart in sequence; this will prevent
mechanical tension.
Figure 7: Tightening clamping blocks
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
23